Play Mode - Ricatech RMC240 Manual De Usuario

· It is not designed for direct communication with a computer.
· It is not guarantee that all USB memory devices (or SD cards) will work on this audio system
IMPORTANT:
Do not disconnect the USB device during USB mode, as this may damage the external device or its files. Please power
off first or select another Mode before safely disconnecting the USB device.
USB Specification
Interface:
- USB 2.0 Full speed, HOST (USB HUB is not supported) Corresponding Flash memory
- Compatible with MPEG Audio 1, 2, 2.5
- Compatible with Layer 1, 2, 3
Compatible with Bit rate: 128 – 320 Kbps
-
- Subfolder nest : 8 levels
- Number of track / titles max 999
- Support ID3 tag V2.0
PROGRAMMING TRACKS
Up to 20 tracks can be programmed to play tracks on an Audio or MP3-CD, USB Device or SD Card in the desired
sequence.
1. In ― STOP ― position, press PROGRAM /
2. Press the FORWARD SKIP /
number appears on the display.
3. For MP3 Programming: press and hold the PLAY/PAUSE key /
4. Press PROGRAM /
5. Repeat steps 2-3 to select and store all desired tracks. ― FULL ― is displayed if you attempt to program more than 20
tracks.
6. Press PLAY/PAUSE /
Erasing the Program – by Remote Control or on the Main Unit
You can erase the contents of the memory as follows:
In Stop position: Press ― STOP ― once, or
-
During Playback: Press ― STOP ― twice, or
-
- Turn the ON-OFF Switch/Volume Control to OFF, or
- Select another sound source/function, or
- Press the CD OPEN/CLOSE button to open the CD door.(at CD mode)

PLAY MODE

Repeat Play Mode for CD-DA or MP3 Playback
1. Press REPEAT /
2. The default Play Mode function is OFF.
3. For CD-DA playback there is a choice of 2 Play Modes: ―REPEAT 1‖ / ―REPEAT ALL‖
4. For MP3 Playback there is a choice of 3 Play Modes: ―REPEAT 1‖ / ―REPEAT FOLDER‖ / ―REPEAT ALL‖.
MP3 RECORDING
Recording from CD to USB / SD
The system is capable of converting (encoding) a whole Audio CD into MP3 format and copy/record this to a USB mass
storage device (e.g. a Flash Drive) or SD card (not supplied).
or SD card.
1. In CD playback mode, press REC /
All manuals and user guides at all-guides.com
to start programming - ―P‖ and P0-01 will start flashing on the display.
or BACKWARD SKIP /
to confirm, the display shows the stored track number and the next store position.
to play the programmed tracks.
on the Remote Control while in Play mode.
to start ripping (recording) to USB/SD card (the default is USB if both
buttons once or repeatedly until the desired track
to select the desired album.
It can also copy a single MP3 track to/from a USB device