Waldbeck Ventura Manual De Instrucciones página 20

EN
20
ASSEMBLING THE REAR AXLE
1. Place the floor (1) upside down. 2.
2. Place the rear axle holder (8) on the base (1). Make the drill holes of the
rear axle bracket (8) flush with the holes on the rear part of the floor (1).
Place screws (16) through the flush holes from below. Install the washers
(16) and nuts on the ends of the bolts. 3.
3. Place the left end of the rear axle guide (9) on the left side of the rear axle
bracket (8) with the welded spacer sleeves facing out. Repeat this step for
the right side.