Waldbeck Ventura Manual De Instrucciones página 24

EN
24
ASSEMBLY OF THE HAND PULL
1. Remove the M8x60 screws and the nuts (18) from the plastic connector
(14). Insert the end of the pull handle (15) into the connector (14). Make
holes in the pull handle and the connector flush with each other.
2. Place the assembly of the handle (15) and the connector (14) into the fork
(13). Make the holes in the pull handle and the connector flush with each
other. Insert M8x60 screws through the holes and tighten them with lock
nuts (18).
MOUNTING THE WALLS
1. Place the carriage in an upright position.