Miele APCL 75 Instrucciones De Instalación página 7

M-nr 11313370
No. Mat. no. Designation
4 Hexagonal-head wood screw 12 x 90
4 Threaded pin M10 x 50
12 Nut M10
8 Washer B10.5
20 Underlay
2 Clamping plate
4 Raised-head screw CEM 6 x 12
2 Hexagonal bolt M6 x 20
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
Measures to be carried out before any service work is commenced
– Carry out appropriate safety tests on the appliance.
– Disconnect all machine utility connections in accordance with the operating instructions.
After service work has been completed, the following measures must be carried out:
– Carry out appropriate safety tests on the appliance.
– Check the appliance for correct operation.
Risk of cuts during service and maintenance work
WARNING
Components may have sharp edges.
There is a risk of cuts during service and maintenance work.
A
Protective gloves should be worn.
Danger of injury due to excess physical strain
WARNING
Danger of injury due to excess physical strain.
Spinal injuries.
A
The relation of the weight of the machines to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Preparing the plinth
A
Level the plinth on the floor.
A
Mark the hole positions.
A
Drill holes measuring 16 mm in diameter in the marked positions, to a depth of approximately 120 mm.
Dessa underlag får inte mångfaldigas eller göras tillgängliga för tredje part utan medgivande från Miele AB. Med ensamrätt.
Ombyggnads- och monteringsanvisning
7 av 34
2019-07-01