Miele APCL 75 Instrucciones De Instalación página 8

8 av 34
A
Insert the plugs in the holes.
A
If a tumble dryer is to be fitted to the plinth, use two 6 x 12 screws to attach each of the clamping plates to the rear
of the plinth, see Fig. 1.
A
Line the plinth up with the underlay supplied (2), see Fig. 2.
A
Fasten the plinth to the floor with the hexagonal-head wood screws (3) and the B13 washers (4), see Fig. 2.
Fitting a washing machine to the plinth
A
Remove the machine feet.
A
Fit two M10 nuts on each M10 threaded pin and counter them such that 15 mm ± 1 mm of thread protrudes, see
Fig. 3.
A
Instead of fitting the machine feet, screw in the M10 threaded pins with the 15 mm long side as far as they will go
and tighten, see Fig. 3.
A
Fit a B10.5 washer on each threaded pin.
A
Lift the washing machine onto the plinth and insert the threaded pins into the plinth.
A
From the inside of the plinth, fit a B10.5 washer and an M10 nut on each threaded pin and screw tight, see Fig. 3.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 4.
en
cs
Montážní návod APCL soklu 75
Důvod: Pomocí soklu lze dosáhnout ergonomické pracovní výšky pračky nebo sušičky.
Obsažené díly
Počet č. m. Název
1 sokl
4 hmoždinka S16
4 podložka B13
4 vrut s šestihrannou hlavou 12 x 90
4 závitový kolík M10 x 50
12 šestihranná matice M10
8 podložka B10,5
20 podložka
2 upínací deska
4 šroub s čočkovou hlavou CEM6 X 12
2 šroub s šestihrannou hlavou M6 x 20
2019-07-01 Dessa underlag får inte mångfaldigas eller göras tillgängliga för tredje part utan medgivande från Miele AB. Med ensamrätt.
Ombyggnads- och monteringsanvisning
M-nr 11313370