Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Please read and save these instructions. This manual contains important Safety Warnings and Operating Instructions. You will need to refer to it
before attempting any application or maintenance. Always keep this manual with the unit so that it will be easily accessible. Failure to read and
follow these warnings and instructions could result in property damage, serious injury, or death.
DESCRIPTION
This pre-assembled sump system is designed for indoor
home sump applications. This system consists of a SP-1000
primary pump and a backup pump.
The primary system operates on 120-volt household electric
power. It is equipped with a 3-prong (GFCI) power cord. The
motor is dielectric oil filled and sealed for cooler running and
is designed to operate under water.
The battery operated back-up sump pump is included in the
event that the primary pump cannot function. It does not
replace the primary pump. A float switch automatically turns
on the backup sump pump when water activates the float. A
battery (not included) must be installed to operate the back-
up sump pump.
UNPACKING
Inspect this unit before it is used. Occasionally, products are
damaged during shipment. If the pump or components are
damaged, contact customer service at 1-877-9RIDGID.
READ & FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS — DO NOT DISCARD
SAFETY GUIDELINES
This manual contains information that is important to know
and understand. This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS. To help
recognize this information, observe the following symbols.
Danger indicates an imminently hazardous
situation which, if NOT avoided, WILL result
in death or serious injury.
Warning indicates a potentially hazardous
situation which, if NOT avoided, COULD
result in death or serious injury.
Caution indicates a potentially hazardous
situation which, if NOT avoided, MAY result
in minor or moderate injury.
Notice indicates important information, that if
NOT followed, MAY cause damage to equipment.
This is the safety alert symbol. It is used to alert you to
potential bodily injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
NOTE: indicates information that requires special attention.
SYSTEM SPECIFICATIONS
Power supply Requirements 120 V, 60 Hz, and 12 V
Dimensions
SYSTEM CONSTRUCTION
Primary Pump
Backup Pump
All manuals and user guides at all-guides.com
Model RSS-1000 – Operating Instructions and Parts Manual
14-1/8 in. high x 11-1/4 in. base
Stainless Steel and Cast Iron
Thermoplastic
Ridge Tool Company
GENERAL SAFETY INFORMATION
CALIFORNIA PROPOSITION 65
This product or its power cord MAY contain
chemicals, including lead, known to the
State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
WORK AREA
• Do NOT operate pump in explosive atmospheres, such as
in the presence of flammable liquids, gases, or dust. Pump
motors create sparks which MAY ignite the dust or fumes.
• Keep bystanders, children, and visitors away while installing
pump. Distractions CAN result in mistakes.
ELECTRICAL SAFETY
• This primary pump must be plugged into a properly
installed GFCI grounded outlet. Never remove the
grounding prong or modify the plug in any way. Do NOT use
any adapter plugs. Check with a qualified electrician if you
are NOT sure the outlet is grounded. If the pump should
electrically malfunction or break down, grounding provides a
low resistance path to carry electricity away from the user.
• Electrical wiring MUST be performed by a qualified electrician.
Improper wiring COULD result in fatal electrical shock.
• Do NOT abuse cord. NEVER use the cord to carry the
pump or pull the plug from an outlet. Keep cord away from
heat, oil, sharp edges, or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of
electrical shock.
• Do NOT expose battery to sparks or fl ames as an explosion
or fi re could result.
• Battery acid is corrosive. Avoid spilling on skin or clothing.
Eye protection must be worn when handling the battery.
• A Ground Fault Circuit Interrupter (GFCI) is required.
• Before using, test the Ground Fault Circuit Interrupter
(GFCI) to insure it is operating correctly. A GFCI reduces
the risk of electrical shock.
• Do NOT use an extension cord. This increases the risk of
electrical shock. If necessary, install a properly grounded outlet
closer to the pump.
PERSONAL SAFETY
• If the basement has water or moisture on the fl oor, do NOT
walk on wet area until all power is turned off. If the shutoff box
is in the basement, call an electrician. Remove pump and either
repair or replace. Failure to follow this warning COULD result in
fatal electrical shock.
GROUNDING
BLADE
POWER CORD
Figure 1
GROUNDED OUTLET
TEST
RESET
353502-005 7/11
Publicidad
Tabla de contenido
