Commissioning - Danfoss RX1 Instrucciones De Instalación Y Instrucciones Del Usuario

All manuals and user guides at all-guides.com
GB - Commissioning Instructions
GB
Thermostat (refer to page 3 for thermostat type)
Step 1. Type A Press & hold buttons
Type B Press & hold LEARN button for 3 seconds
Type C Remove dial, press & hold LEARN button for 3
seconds (located under setting dial)
Do not replace knob until Learn process is complete
NOTE: Thermostat now transmits continuously for 5 minutes.
Receiver
Step 2. RX1
Press and hold buttons PROG and CH1 for 3 seconds
until green light fl ashes
RX3 (if applicable)
Step 3. RX2 /
Stat 1 - perform steps 1-2 for CH1
Stat 2 (RX2 & RX3)
Wait 5 mins, perform step 1, then press
PROG + CH2 on RX2/RX3
Stat 3 (RX3 only)
Wait 5 mins, perform step 1, then press
PROG + CH3 on RX3
Use only
during
programming
Emergency 'ON' button, press
Receiver status
if communication fails, turns
LED, fl ashes when
on heat, returns to AUTO when
receiving communication is re-established.
10
and + for 3 seconds
Zone status
LEDs, lit when
'ON'