Uline H-4039 Guia De Inicio Rapido

H-4039
SPILL CONTAINMENT
WORKSTATION
CONNECTORS
TOOL NEEDED
Plastic or Rubber Mallet
1. Locate one of the indented rectangular areas on
the outside surface of the workstation. (See Figure 1)
This is the recommended area for placement of the
connectors.
2. Place two workstations side by side. Position the
connector over the top edges of the workstations.
(See Figure 2)
CAUTION! Do not use your hand to hammer
down the connector. This may result in injury
and cuts.
PAGE 1 OF 6
1-800-295-5510
uline.com
ASSEMBLY
3. Once the connector is positioned over the top
edges of both workstations, hammer down the
connector using a plastic or rubber mallet.
(See Figures 2 and 3)
Figure 1
4. Ensure the connector is flush with the top edge of
the workstations. (See Figure 4)
Figure 2
5. Repeat steps 1 through 4 on opposite end of
workstation.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
0321 IH-4039
Figure 3
Figure 4