Connecting The Cables; Adjusting The Focus; Initial Configuration - Messoa NCC800 Guia De Inicio Rapido

2.2 Connecting the Cables

1. Optionally connect alarm input/output devices to the camera.
2. Optionally connect a speaker and microphone to the camera.
3. Connect the camera to a power source, using one of these options:
• DC 12V: Connect to the provided power adapter.
• PoE: Using an Ethernet cable, connect the LAN port to a PoE-
capable network device. Power will be supplied through the
Ethernet cable.
4. Optionally connect a video monitor if you want to perform focus
and iris adjustments during the installation.
5. For NCC800WL, connect the USB Wi-Fi dongle to the USB port of
the camera for wireless capability.

2.3 Adjusting the Focus

Loosen the Focus Adjustment Ring screw first and then rotate the ring
to adjust the focus. After adjustment, fasten the screw.

3. Initial Configuration

Before connecting the camera to your network infrastructure, or to a
wireless network, you have to connect the camera to a computer
first to perform initial configurations.
1. Configure the computer's IP address to one other than the camera's
default IP address, such as:
• IP Address: 192.168.1.100
• Subnet Mask: 255.255.255.0
2. Usning an Ethernet cable, connect the camera to the computer.
The LAN port of the camera supports auto MDI/MDIX so there is no
need to use a cross-over cable.
6 NCC800/NCC800WL
All manuals and user guides at all-guides.com
l Quick Start Guide