GBD CB24 Manual Del Usuario página 6

Controls
Button Function
A
Turns the lighting system on and off at maximum
intensity.
B
Turns the Motor off.
Press and hold for approximately 5 seconds to Lock
/ Unlock the Keyboard, for example in order to clean
the surface.
C Turns the Motor on at Speed one.
D Turns the Motor on at Speed two.
R
E
Turns the Motor on at Speed three.
F
Activates/Deactivates intensive speed from any other
H
speed, including motor off. This speed is set to operate
for 10 minutes, after which the system returns to the
speed that was set before. Suitable to deal with maxi-
mum levels of cooking fumes. Can also be deactivated
G
by pressing button B.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on/off.
F
G
24H function
Turns the motor On/Off at speed one and allows
recirculation for 10 minutes every hour. It cannot be
E
activated if the Intensive or Delay functions are in use.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for approxi-
D
mately 5 seconds.
These indications are only visible when the motor is
turned off.
C
B
A H
Delay function
Activates/Deactivates automatic switch-off with a 30'
delay. Suitable to complete elimination of residual
odours. Can be activated from any position. It cannot be
activated if the Intensive or 24H functions are in use.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Remote control on/off.
R Remote control receiver.
Lighting
• For replacement contact tech-
nical support ("To purchase
contact technical support").
6
All manuals and user guides at all-guides.com
Led
On/Off.
-
The buttons turn light up one at a time in cycle.
On/Off.
On/Off.
On/Off.
Flashes once a second.
Button B (Flashes twice)-Alarm Activated.
Button B (Flashes once)-Alarm Deactivated.
On/Off.
B flashes three times.
When the procedure terminates, the indication
shown previously turns off:
Button G flashes, indicating the need to wash
the metal grease filters. The alarm is triggered
after the Hood has been in operation for 100
working hours.
Button G flashes, indicating the need to
change the activated charcoal filters, and also
to wash the metal grease filters. The alarm is
triggered after the Hood has been in operation
for 200 working hours.
On/Off.
Button B (Flashes twice)-Remote control
Activated.
Button B (Flashes once)-Remote control
Deactivated.
-