König Electronic KN-MICW330 Manual página 3

All manuals and user guides at all-guides.com
1. Power:
2. Button :
3. Button :
4. Set Button:
5. LCD Display:
6. GP:
7. CH:
8. CH:
9. FREQ:
10. RF Level Indicator:
11. AF Level Indicator:
12. MANUAL:
13. SCAN:
14. PRESET:
15. Volume Control:
16. Antenna:
17. Balanced Output:
18. Unbalanced Output:
19. Mic/Line Switch:
20. Squelch:
21. DC IN:
22. DC OUT:
Press for 4 seconds to power the receiver on or off.
Used to select your desired mode, and search channel
forward.
Used to select your desired mode, and search channel
backward.
Press for 2 seconds, until "MUTE" is displayed, release the
button, the LCD will flash, press button  or  to change
the channel. Stop pressing the button and let the LCD
display flash five times. This will lock the setting.
Shows the channel number, frequency level, RF & AF
signal strength, and set-up mode.
Indicating the preset group number, P1, P2
Indicating the preset channel number, C1, C2
Indicating the channel number, 001, 002, 003
Indicating the frequency.
5-segment meter glows to indicate the RF signal strength.
The more segments glow, the stronger the received
signal. If none of these segments glow, no signal is being
received.
5-segment meter glows to indicate the audio signal
strength. The more segments glow, the stronger the
received signal. If none of these segments glow, no signal
is being received.
Use this mode to select an interference-free channel
manually.
Use this mode to select an interference-free channel with
the auto-scan function.
Use this mode to select an interference-free channel from
the preset-groups. There are 4 preset groups. In each
group there are 8 preset channels which are suitable for
8 transmitters simultaneously.
Use this rotary control to adjust the receiver' output level
to match the input sensitivity of an audio mixer or an
amplifier.
Fixed-length UHF antenna, permanently mounted.
3-pin XLR connector provides balanced low-impedance
output.
Unbalanced 6.3mm mono jack audio output for connecting
to, for example a guitar amplifier.
Use this to adjust the output (XLR balanced connector and
6.3ϕ unbalanced phone jack) for microphone (-20dB) or
line-level (0dB).
Use the squelch to adjust the output level to suppress noise.
The higher the squelch control, the lower the sensitivity of
the receiver and smaller the service area of the system.
Set the squelch to minimum before turning the receiver on.
DC Input connector for the supplied AC adapter.
Use this to connect the supplied cable to the receiver and
the microphone.
3