König Electronic KN-MICW330 Manual página 8

All manuals and user guides at all-guides.com
3.
NOTE: When there is any outside interference on the current preset group, please switch
to the next preset group. If 4 preset groups are all under interference, please use
auto-scan mode or manual mode to set up the system.
Inserting batteries into the handheld microphone / bodypack transmitter
1. Open the battery cover and insert batteries into the battery compartment according
to the polarity (+)(-) marks. The transmitter can not work with incorrectly inserted
batteries.
2. Push the ON/OFF switch to "ON" to switch the power on, the LCD display shows the
battery power level. If it displays low power, the inserted rechargeable batteries can be
charged by using the supplied DC plug cable. Connect the DC cable to the transmitter
and microphone or bodypack to charge the batteries. It can take up to 10 hours to fully
charge the batteries. Use only rechargeable NiMH batteries
S E T
P O W E R
Setting up the receiver and microphone
1. Switch the receiver on and check the frequency and volume level.
2. Switch the transmitter and amplifier/audio mixer on.
3. Adjust the channel setting of the transmitter according to the receiver's channel setting.
4. Test the microphone and adjust the levels on your audio mixer or amplifier.
Stop pressing the buttons and let the LCD display
flash five times to lock the setting.
V O L .
M IN M A X
D C O U T
8
or