Installation - Brilix LED-P100 Manual Del Usuario

1. Preparation steps that must be taken by an
electrician before the light installation: See picture 1.
TO THE POWER SUPPLY UNIT
CAST IN PARAFFIN
INFLEXIBLE
INSTALLATION PIPE
Picture 1
1. Make sure that the electric system and its installation meet the requirement of your governmental or local
bodies. The installation of the underwater light can be operated only by a qualifi ed electrician.
a) The junction box of the low-voltage transformer for 12V model of the light must be placed at least
350 cm from the edge of the pool, see picture 1.
b) The light and all metal components placed 240 cm from the edge of the pool must be appropriately
protected by infl exible materials and the binds must be waterproofed.
c) The assembly consol must be properly installed in a way that the top edge of the light lentil is at least
45 cm under the pool water level, see picture 1.
MINIMUM 120 CM
3
WATER LEVEL
MINIMUM 45CM FROM THE WATER
LEVEL TO THE TOP EDGE OF THE LENTIL
29,6 CM
6,6 CM
THE CONCRETE MUST BE
RECEDED AROUND THE
BAY IN ORDER TO CREATE
THE SPACE FOR THE COM-
PACTPADDING FROM THE
PLASTER.
EN