Mounting The Unit - Korenix JetNet 3008 Serie Guía De Instalación Rápida

Introduction
JetNet 3008/3008f Industrial Ethernet Switch, conforming IEEE 802.3 and 802.3u standard,
supports 8 10/100Base TX (JetNet 3008) or 6 10/100TX plus two 100FX Fast Ethernet fiber
ports in either multi-mode type (JetNet 3008f-m) or single-mode type (JetNet 3008f-s).
The JetNet3008/3008f adopts rugged metal case design to operate in harsh environments
o
B
(-25
B
users if a port link fails or with the power fails. Alarms can be enabled/disabled by a 9-pin dip
switch. JetNet 3008/3008f is recommended to be powered by DC 24V with 12~48V range
from the 6-pin removable terminal block.
Package contents Check List
Box contents
�
JetNet 3008/3008f Switch
�
Quick Installation Guide
�
CD User Manual

Mounting the Unit

�
Din-Rail mount: Mount the din-rail clip
screwed on the rear of JetNet 3008/3008f on the DIN rail.
About the DIN Rail installation, please refer
user's manual.
Grounding JetNet 3008 / 3008f Switch
There is one grounding screw on the bottom side
of JetNet 3008/3008f. Connect the earth ground
screw of switch to the grounding surface to ensure
safety and prevent noise. See, Figure-1
All manuals and user guides at all-guides.com
o
C~70 C); It also provides IP-30 standard protection. It features one relay output to alarm
Figure-1
Earth Ground
Screw
Alm
PW1 PW2
Earth Ground
Warning: Do not connect to AC line-Natural
Alarm Control
port 1~8 power