_ECL-75_100.book Seite 16 Freitag, 22. Juli 2005 5:01 17
Safety information
2
Safety information
2.1
General safety
Always disconnect the power supply when working on the charging current
distributor!
If the cable is damaged, it must be replaced to prevent possible electrical hazards.
Do not operate the device if it is visibly damaged.
This device may only be repaired by specialist personnel. Inadequate repairs can
lead to considerable hazards.
Should your device need to be repaired, please contact WAECO customer services.
Ensure that the charging current distributor is kept out of the reach of children!
2.2
Operating the device safely
Do not operate the device near flames or other heat sources (heating, direct sunlight,
gas ovens etc.).
Do not immerse the device in water.
Protect the device and the cable against heat and moisture.
Caution!
WAECO International will not be held liable for claims for damage resulting
from the following:
–
Installation errors
–
Damage to the system resulting from mechanical influences and overvolt-
age
–
Alterations to the device made without the explicit permission from WAECO
International
–
Usage for other purposes than those described in the installation manual.
Warning!
To prevent short circuits, always disconnect the negative terminal of the vehi-
cle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also be dis-
connected.
Warning!
Insufficient supply line connections could result in short circuits which
–
Cause cable fires
–
Trigger the airbags
–
Damage electronic control devices
–
Cause electric functions to fail (indicators, brake light, horn, ignition, light).
3
Scope of delivery
Quantity Description
1
Control unit
1
High-current load relay
16
All manuals and user guides at all-guides.com
charging current distributor