Worx WT645K Manual Del Usuario página 8

Fig 5
Fig 6
08
Palm Sander
NA-WX645K-M-051107.indd 8
All manuals and user guides at all-guides.com
allows efficient material removal.
Operate your sander in long sweeping movements across
your workpiece and even across the grain. For a finer
finish, always use a fine type sand paper and only move
the sander in the direction of the grain and never across
the grain.
Do not allow your sander to remain in the same position
otherwise you will remove material and create an uneven
surface.
WORK HINTS FOR YOUR PALM
SANDER
If your power tool becomes too hot, especially when used
at low speed, set the speed to maximum and run it with
no load for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always use sand paper that is
suitable for the material you want to sand.
Always ensure the work-piece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of
the sanding finish.
Start your sander before sanding and turn it off only after
you stop sanding. For the best results, sand wood in the
direction of the grain.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away it will damage
the base-plate. The guarantee does not cover base-plate
wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and
fine grit for the final surfaces. If necessary, first make a test
run on scrap material.
Use only good quality sandpaper.
The sandpaper controls the sanding efficiency, not the
amount of force you apply to
the tool. Excessive force will reduce the sanding efficiency
and cause motor overload. Replacing the sandpaper
regularly will maintain optimum sanding efficiency.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically and
if damaged, have repaired by authorized service facility.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
WT645K
2005-11-7 9:17:33