Herschel SUMMIT 2600 Instrucciones De Instalación Y Funcionamiento página 5

Diagram 2: Mounting options and minimum distances to objects.
CAUTION:
• Ensure mains power is OFF before commencing installation.
• The supplied mains cable must not contact the top surface of the heater during operation.
• Heater must not be located immediately below a socket outlet. Electrical connections must be made
outside of the footprint of the unit to avoid heat build-up. If the heater is to be mounted on an incline
(e.g. sloping roof), ensure the electrical connection is located below the lowest end of the heater.
• Joists, beams and rafters shall not be cut or notched to install the appliance.
• This heater is not intended for ceiling-recessed installation.
• The identification mark and model reference should be visible after installation.
• The SUMMIT must not be attached facing or close to any combustible material (eg, wood or PVC
cladding, fascia or soffit) or other materials that could blow onto the heater.
• The fixed wiring insulation coming into contact with parts with a temperature rise of greater than
50°C must be protected, for example, by sleeving having an appropriate temperature rating.
OPERATION BY REMOTE CONTROLLER:
The Herschel SUMMIT 2600R is operated from the remote control supplied with the heater. The SUMMIT
2600 has no remote control.
Insert 2 x AAA Alkaline batteries into the remote control.
Button Function (Heater On)
1 Turns heater on or off
2 Increase Heat Level or
Timer hours
3 Decrease Heat Level or
Timer Hours
4 Enable Timer
adjustment
5 Enable Heat Level
adjustment
Remote Control Function
Function (Heater
Off)
Turns heater on to
Level 1 (minimum)
Turns heater on to
Level 2 (Maximum)
ENGLISH
LED display on
heater
L1
L2
00 - 24
L [n]