Cleaning; Troubleshooting - Wilfa SPLASH KW-60 Manual De Instrucciones

CLEANING

1. Rinse the scale under water and clean the scale with a slightly damp cloth and
set it to dry.
2. Do not use chemical/abrasive cleaning agents.

TROUBLESHOOTING

Problem
The LED display is
dim or displays Lo
The device is not
starting when the
TARE button is
pressed
The LED display
shows " "
The LED displays
" "
The measurement
is not accurate/
LED displays " "
KITCHEN SCALE · KW-60
6. When it shows the negative value,
press the ON/OFF/TARE button
again, it will clear to zero.
7. If there is no operation, the scale
will switch off automatically in
about 1 minute. Or you can press
and hold the ON/OFF/TARE button
for about 2s to switch the scale off.
Possible reasons
The power is not
enough
The battery level is too
low.
The batteries are not
inserted correctly
Overload
The objects, which
weigh over 1000g, are
placed on the scale
before it is switched on.
The weight is unstable
when you turn on the
scale.
9
Solutions
Please replace with 3xAAA
new batteries
Please replace with 3xAAA
new batteries
Please insert the batteries
according to the instructions.
Please remove the weight on
the scale to protect the weight
cells. Buy a new scale with
higher weight range.
Remove the objects from the
scale, wait until it displays zero,
then you can start weighing.
Keep the weight stable when
you turn on the scale.
EN