Switching Off The Appliance; Useful Tips; Disassembling The Deep Fryer - Essentielb EFSP 2146i Instrucciones De Uso

Freidora semiprofesional
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

7.
Place the food into the basket(s) (for optimal results, the food must be dry). Never fill the basket
when it is immersed in the oil.
8.
Lower the basket(s) into the oil gradually to avoid bubbling and oil splatter. The cooking process
begins.
9.
If the timer was set: once the time has elapsed, a beep will be heard and the deep fryer will switch
off.
10.
Once the food is cooked, raise the basket(s). Allow the ingredients to drain by holding the basket(s)
over the tank or hooking it onto the side.
!
Warning! When you lift the lid, extremely hot steam may suddenly be released. Take care
not to get burned and lift up the lid gently by its handle.
11.
After use, set the temperature selector as well as the timer to the 0 position, unplug the appliance
and leave it to cool completely before cleaning it.
!
Warning! In the event of overheating, the safety device automatically switches the deep
fryer off. Unplug the appliance and wait for it to cool down. To reactivate the deep fryer,
press using a sharp object (a pen for example) on the "RESTART" button at the back of
the control unit, located above the cable tidy.
Wait for the
heating element
to cool down
30
V.1.0
using the appliance
RESTART
Reset by pressing on the button
under the RESTART wording

Switching off the appliance

To switch the appliance off when in operation:
Set the temperature selector to 0, or
Set the timer selector to 0, or
Unplug the appliance,
And leave it to cool down completely.

Useful tips

Dry your ingredients before putting them in the deep fryer, especially fresh fries. Ingredients that are
too moist can make the oil bubble and may cause it to spill over the sides.
Wait until the appliance has finished preheating before placing food in the basket(s).
When cooking frozen or deep frozen ingredients, remove the frost and ice crystals which can cause
the oil to bubble and scalding splashes of oil to be ejected.
Make sure that all the ingredients are approximately the same size so that they cook evenly. Do not
use food that is too large.
Do not overload the baskets.
Some ingredients may be covered in breadcrumbs or covered in batter for frying.
Remember to drain the ingredients well once the cooking time has elapsed.
Make sure the room is well ventilated when the appliance is in use.

disassembling the deep fryer

The deep fryer must be allowed to cool completely before it is disassembled.
1.
Remove the basket by the handle.
2.
Remove the control unit with heating element by sliding it upwards.
3.
Grasp both sides of the tank and gently lift it out.
31
V.1.0
disassembling the deep fryer

Publicidad

Tabla de contenido
loading

Tabla de contenido