Herschel Select XLS Serie Instrucciones De Instalación Y Funcionamiento página 6

Fixed wiring into mains. Professional installation required
The panel may be mounted using the EASYFIX mounting bracket and "hard wired" to the electrical supply. For the
white panel range this will require removal of the plug and connection to a suitable connection box positioned
adjacent to the heater. This method of installation must only be carried out by a competent electrician. The SMART-R
box on the rear of the panel should be located at the bottom of the panel. The panel can be mounted in either
landscape or portrait position (see detailed installation instructions).
WARNING
Wiring to this appliance must be connected in accordance with the relevant national electrical safety standards. It
is a Class 1 appliance and must be earthed.
When placed in public areas, installation must comply with relevant local electrical standards. For certain public
buildings like schools and care homes the heaters must be installed according to the specific legislation for these
types of buildings.
The electrical supply to each heater should be provided by connecting to a circuit protected by a fuse or residual
current device (RCD) or Ground Fault circuit interrupter (GFCI ) suitable for the electrical rating of the appliance.
Colour coding used in the supplied mains cable: BROWN wire is to be connected to LIVE ('L'), the BLUE wire to
NEUTRAL ('N') and the GREEN/YELLOW wire to EARTH ('E').
CAUTION
Ensure mains power is OFF before commencing an installation involving fixed wiring. Any fixed wiring outside the
heater coming into contact or close proximity to the heater must be protected by sleeving with a temperature
rating of at least 90°c.
All cabling behind the appliance must take the shortest route to the edge of the heater.
Ensure that the power cable is not coiled. Shorten the power cable if possible and do not place excess cable on the
rear of the heater.
Electrical connections must not be made behind the heater regardless of wall or ceiling-mounting position.
The heater is not to be located immediately below a socket outlet in either wall or ceiling-mounted positions.
DO NOT
drill through the heater as this will cause irreparable damage and is also dangerous.
DO NOT
connect a heater that is damaged in any manner to the power network.
For mounting the Herschel panel use the supplied mounting hardware only and install in accordance with the
installation guide.
Select XLS
ENGLISH