Telcoma Automations TANGO NOIRE Manual De Instrucciones página 33

GB
STANDARD PROGRAMMING
For correct, easy programming, it is essential that the following
instructions are followed to the letter.
1. Preliminary operations
- Connect an antenna tuned to 433 MHz to the antenna terminal on
the receiver. Alternatively, diminishing the receiver specifications,
a piece of wire approx. 20 cm long may be connected
- Once the receiver has been connected to the control unit or the
necessary connections onto the terminal board have been com-
pleted, switch on.
- As soon as the receiver is powered, it carries out an internal test,
shown by LED L2 coming on for 3 seconds.
2. Self-memorisation
- Upon pressing key P1 for an instant the relative
led will blink 5 times.
- Within this period of time, transmit with the
radio control required for use.
- Fixed indicator lights lasting about 3 seconds indicate that the
code has been successfully stored.
- Immediately after this the led starts blinking again, waiting for a
new radio control signal to be memorised; if it receives none after
blinking another 5 times, the receiver automatically exits from the
programming stage.
Our transmitter and receiver are already operative!
- Follow the same procedure also for the other P keys.
3. Meaning of the blinking LEDs
- L2 on for 3 seconds: as soon as the receiver is powered.
- Brief flash of one led: when transmitting with a correctly memo-
1
L1 P1
33