How To Use Your Steam Generator Iron; Filling With Water; Turning The Machine On - Dupray SteamIron Plus Manual De Instrucciones

HOW TO USE YOUR STEAM GENERATOR IRON

FILLING WITH WATER

Remove the boiler cap (6) and fill with 1L (34 oz) of water. Securely replace the boiler cap.
IMPORTANT:
Never put anything else than clean water inside the boiler.
IMPORTANT:
Do not overfill with water. Leave space for steam!
PLUGGING THE MACHINE
Unravel completely the electrical cord. Connect the electrical cord to a 15 or 20 amp 110V / 120V power outlet
(make sure the circuit is not already used by another high wattage appliance).

TURNING THE MACHINE ON

STEAM IRONING: Press the iron activation button
and wait about 10 minutes for the SteamReady™ indicator (4) to light up. Set the
thermostatic control (C) to the position that corresponds to the fabric you wish to iron.
When the thermostat light (D) goes off, the iron is ready to use. Adjust the steam
pressure control (3) and the humidity control (7) according to the fabric you are ironing.
NOTE:
The thermostat light (D) will come on and off during use to maintain the iron plate at the optimal temperature.
IMPORTANT:
Always follow the manufacturer's ironing recommendations for the fabric.
All manuals and user guides at all-guides.com
and the boiler activation button
DRY IRONING: Press the iron activation button
control (C) to the position that corresponds to the fabric you wish to iron. When
the thermostat light (D) goes out, the iron has reached the proper temperature
and is ready to use.
NOTE:
In this position the unit will not produce steam.
NOTE:
Do not press the steam release button (A) to iron without steam.
and set the thermostatic