Warm Audio EQP-WA Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HARDWARE CONTROLS — REAR PANEL
Power
The
EQP-WA
requires
appropriate
for
the
230v operation, from the rear voltage selector switch. Power input is via a standard fused IEC
power receptacle with built in fuse access, chassis mounted on the rear of the unit. Power is
turned on and off via the toggle switch labeled 'ON/OFF' on the right side of the unit's front
panel.
Audio Connections
The EQP-WA has both XLR and ¼ inch TRS balanced inputs and outputs, rear chassis-mounted,
operating at line level. Unbalanced connection is also possible via a ¼ inch TS cable. It is not
advised to connect both input connectors or both output connectors at once.
Tube Gain Adjust
Located next to the output section, this control provides for approximately 6db of adjustable
gain in the tube makeup amplifier, generally between -3 and +3dB. This will allow users to match
two units for stereo use with either a test tone or source material; or to match one or two units
for unity gain within a particular setup. At fully clockwise (when facing rear of unit), the control
is essentially by passed and the EQ has it's original default level. At fully counterclockwise,
the EQ will be at full attenuation.
Aside from its technical purpose, this feature allows for some additional creative use. For instance, hotter bus material
can benefit from the slightly improved headroom and transparency of pulling down the tube gain lower. Conversely, solo
instruments and vocals (acoustic guitar or female vocal, for example) can benefit from the added tube roundness and
girth of having the tube gain pulled up higher. As with anything, let your ears be the final judge of how to use this feature.
5
a
3-pin,
grounded
territory
in
which
IEC
cord,
and
it
is
sold.
Voltage
should
ship
with
the
is
selectable
between
power
cord
1 15v
and

Publicidad

Tabla de contenido
loading

Tabla de contenido