Keypad Arming & Disarming; Arming; Disarming; Bypassing A Zone - HIKVISION Pyronix MX Serie Guia Del Usuario

Status indications
If a button on the keyfob has been programmed as 'Show Status' , the LED at the top will flash to indication the current status of
the alarm system. Red means that the system is armed,
it indicates that the control panel is in fault.
1. Enter a valid user code, or present a valid proximity tag.
2. Deselect the areas that do not require arming.
3. Press t to start exit timer.
4. Leave premises via agreed exit route.
1. Enter premises through agreed entry point to start the entry timer.
2. Enter a valid user code, or present a valid proximity tag.
3. Select the area(s) to disarm the numerical and/or a, b, c or d keys.
4. Press t.
1. Start the arming procedure.
2. When the exit time appears on the screen press t.
3. Enter the zone to be bypassed then t, repeat for multiple zones.
4. Press x to return to arming.
Please note: This only bypasses the zone for this arm cycle only. The next time the area is armed, the zone will be active
unless bypassed.
1. Press d and enter a valid user code or present a proximity tag.
2. Press x until the display shows 'REVIEW LOGS?' then press t.
3. To view the panel log press t or press x to move to the access control log.
4. Press t to view the access control log or x to move to the voice log.
5. Press t to view the voice log or press x to return to the main menu.
Moves backward in the log.
[
Moves forward in the log.
]
Expands log entry to show more information.
c
Exits the log
x
Any faults that occur on the system will cause\ (fault LED) to flash on the keypad.
1. Enter a valid code or present a valid proximity tag and the fault will be displayed.
2. If the fault no longer exists you can clear the fault from the LCD screen by pressing x.
Please note: If at this point if the panel displays 'Restore Required' , you should call your engineer as soon as possible.
green indicates the control panel is disarmed. If the LED flashes amber,
KEYPAD ARMING & DISARMING

BYPASSING A ZONE

VIEWING THE LOGS

VIEWING & CLEARING FAULTS

Arming

Disarming

Navigating to the Logs

Reading the Logs

5