Setup And Firmware Update; Warranty - Midland BTX1 PRO Manual De Instrucciones

phone call answering features in manual mode only.
Adjusting the sensitivity of the microphone (VOX)
To perform this operation you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
3. Your BTX1 PRO is now in "Set up mode".
4. Press shortly the "Backward" button, the red light indicator changes to a steady blue.
5. Now, press "Volume +" or "Volume -" to increase or reduce sensitivity. Every time you
press the Volume buttons the RED light will flash for confirmation. When you reach
the end of the upper and lower limit, the RED light will not flash.
6. Press again the "Backward" button; the Blue light will flash several times, in order to
let you know the selected sensitivity:
One flash = VOX disabled
Twice = low sensitivity
3 times= normal sensitivity
4 times= high sensitivity (default setting)
5 times = highest sensitivity
The light indicator is back to RED ("Set up mode") and the changes are confirmed.
7. If needed, you can adjust again the sensitivity repeating the steps from point 1,
otherwise exit the Setting mode by double clicking the "Middle" button. Once the red
light turns off, the blue led starts blinking. Now you can use your BTX1 PRO.
Disabling the VOX feature (Intercom and telephone)
Follow all the procedure described in the previous steps and choose the option of only
one flash (VOX disabled).
Wired connection always in background
This feature let you keep the wired connection always on, even when the phone or the
intercom is open (but not when you are in FM radio mode).
By default the Background feature is ON.
Disabling:
› Enter the "Setup" mode:
26
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Press the "Forward" and "Middle" button together for 3 seconds. The blue LED will
flash three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the BTX1 PRO.
Enabling:
Follow the same procedure up described; now the blue LED will flash once.
To exit the "Setup" mode, double click the "Middle" button.

Setup and Firmware update

It is possible to configure and update the firmware of your BTX1 PRO using the USB
connection to your PC. On the Midland web site www.midlandeurope.com in the BTX1
PRO page you can find the PC software and the new firmware updates if available.
ATTENTION DO NOT CONNNECT THE UNIT TO THE PC BEFORE you DOWNLOAD
AND INSTALL THE SOFTWARE
Use at your own risk
The use of the device will impair your ability to hear other sounds and others around you.
Listening to music or speaking on a telephone may prevent you from hearing others
around you and distract you from riding safely. The use of such device while riding may
endanger you and others, and its use, in some areas, could not be allowed.
Using this device at a high volume may result in permanent hearing loss.
If you experience ringing in your ear or any other hearing related pain, reduce the volu-
me or discontinue using this device. With continued use at high volume, your ears may
become accustomed to the sound level, which may result in permanent damage to your
hearing.
Please use this device at a safe volume level.

Warranty

The warranty lasts 24 months for the main device and 6 months for the accessories (bat-
www.midlandeurope.com