Fuse; Seat Adjustment Lever; Fuel Shut Off Valve; Cutting Height Lever - Husqvarna Z 246i Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROLS

Fuse

The 20 amp primary fuse is located on the left
hand side of the machine. It is accessed by tilting
the seat forward. The fuse is a flat pin type used
in automobiles.

Seat Adjustment Lever

The seat can be adjusted lengthways. When
making adjustments, the lever below the right side
of the seat is pulled up, after which the seat can
be moved backward or forward.

Fuel Shut Off Valve

The fuel shut off valve is located at the right rear
of the seat. The valve is off when the handle tab is
turned perpendicular to the fuel line.

Cutting Height Lever

To set the deck cutting height, pull the cutting
height lever inwards and move it to the desired
height notch.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
IMPORTANT INFORMATION To obtain an
even cutting height, it is important that the air
pressure in all tires is 15 psi / 103 kPa / 1 bar.

Bypass Linkages

Transaxle bypass linkages must be engaged
when pushing or pulling the mower. The release
levers are located on each side of the rear of the
unit below the rear engine guard. See Moving
Machine By Hand in the Operation section.
WARNING!
located close to the muffler. To prevent burns,
the engine should be shut off and allowed
to cool before the bypass linkage levers are
handled.
Bypass linkages are
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido