Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Pull back on collar, insert new spray tip and releasecollar.
Tug on spray tip to make sure it is securelyin place.
Usage Tips
•
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
•
If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
•
DONOT get closer than 6 inches (15 cm) when cleaning
tires.
2-1N-1 Soap System
A. CAUTION Chemicals can cause bodily injury, and/or
property damage.
• NEVER usecausticliquid with pressure washer.
• UseONLYpressure washersafedetergents/soaps. Followall
manufacturers instructions.
Cleaning and ApplyingDetergent with the
Project Pro@ PerfectMix
TM
Siphon
To apply undiluted detergent using the blue
PerfectMix
TM
siphon, follow these steps:
1.
Review use of spray tips.
2.
Attach PerfectMix
TM
siphon hose to
pump and PerfectMix
TM
concentrate
bottle.
//
//
NOTICE Contact with the hot muffler can damage detergent
siphoning tube.
• Wheninsertingthe siphonintoa detergent s olutionbottle,route
thetubeso asto keepit from inadvertently contacting the hot
muffler.
3.
Make sure black detergent spray tip is installed.
NOTE:Detergent cannot be applied with the high pressure
spray tips (White, Yellow or Red).
4.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Startingthe enginewithoutall the hosesconnected and without
thewaterturnedONwill damage the pump.
• Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
5.
Start engine following instructions How to Start Your
Pressure Washer.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7.
Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOTallow detergent to dry on
(prevents streaking).
Cleaningand ApplyingDetergent with
the Standard Clear Siphon
To apply diluted detergent using the
standard clear siphon tube, follow these
steps:
1.
Review use of spray tips.
2.
3.
Attach clear siphon hose to barbed fitting on pump.
Mix detergent solution as required by job.
4.
Placesmall filter end of clear siphoning tube into
container with diluted solution as described above.
NOTE:DONOT insert standard siphon hose in Extreme
Concentrate.Failure to dilute concentrate will cause excessive
application and consumption of solution.
NOTE:Make sure the filter is fully submerged in fluid while
applying solution.
NOTICE Contact with the hot muffler can damage detergent
siphoning tube.
• Wheninserting the siphoninto a detergent s olution bottle,route
the tubeso asto keepit from inadvertently c ontacting the hot
muffler.
5.
Make sure black detergent spray tip is installed.
NOTE:Detergentcannot be applied with the high pressure
spray tips (White, Yellow or Red).
6.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Startingtheenginewithoutall the hosesconnected andwithout
the waterturnedONwill damage the pump.
• Damage to equipment r esulting from failureto follow this
instructionwill void warranty.
7.
Start engine following instructions How to Start Your
Pressure Washer.
8.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9.
Allow detergent to "soakin" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
IMPORTANT:You must flush the detergent siphoning system
after each use by placing the filter into a bucket of clean
water, then run the pressure washer in low pressure for 1-2
minutes.
14
Publicidad
Tabla de contenido
