Orbegozo CL 76132 M Manual De Instrucciones página 16

CL 76132 M
REMOTE CONTROLLER OPERATION
Point the remote at the infrared sensor to power the fan.
MAINTENANCE
Complying with the following instructions will help you maintain your fan:
Check the parts twice a year. Long periods of rotation may cause parts to become loose.
•
Never clean the engine, the switch box fan and electrical parts with water to prevent short
•
circuits.
You can clean the decorative parts with a soft cloth. Make sure that the fan is off before
•
cleaning it.
No need to grease any part.
•
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that
when you dispose of the appliance, it must be separately collected. Consumers should contact
their local authority or retailer for information concerning the correct disposal of their old
appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low
Voltage Directive 2006/95/EC and the requirements of the EMC directive 2004/108/EC.
HI: turn on the fan at high speed.
MED: turn on the fan at medium speed.
LOW: turn on the fan at low speed.
OFF: turn off the fan at low speed.
LIGHT: ON/OFF –press and release immediately to turn on or off the light.
1H, 2H, 4H, 8H: program operation of the fan (but not light) 1 hour, 2 hours
and 4 hours and 8 hours respectively. to do this, then operate the fan and
press one of these 3 buttons, and after the selected time, the fan stops
working (note: light can not be programmed).
Battery: A23 12v
16