Assembly - Craftsman 580.750840 Instrucciones De Uso

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Bottle Bracket Wireform (2)
• PerfectMix™ Siphoning Unit/Tube
• Engine Oil Pouch
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 5 Multi–Colored Quick Connect
Spray Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolt (4)
• Plastic Handle Knob (2)
• Plastic Knob (2)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Connect detergent siphon tube to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.

ASSEMBLY

6. Verify pump oil dipstick (A) has been installed into pump.
A
7. Connect pressure hose to spray gun and pump.
8. Connect water supply to pump.
9. Attach nozzle extension to spray gun.
10. Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Accessory Tray
1. Place handle (B) onto handle supports (C) connected to
main unit. Make sure holes (D) in handle align with holes
(D) on handle supports.
D
NOTICE It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (E) through holes from inside of
unit and attach plastic handle knobs (F) from outside of
unit. Tighten by hand.
F
3. Place bottle brackets (G) facing outside over holes in
handle supports. Secure bottle brackets with carriage
bolts (H) and plastic knobs (J). Tighten by hand.
J
4. Insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided on handle.
7
B
D
C
E
G
H