Operation - Arctic Cove EVC351 Manual Del Operador

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
UNDERSTANDING THE BASICS
The evaporative cooler is not an air conditioner. It does not
have a compressor and does not require refrigerant.
WARNING:
The evaporative cooler is not an air conditioner and
should not be relied on to cool extremely hot spaces,
such as garages, sheds, or work buildings that do
not have their own primary air conditioning or cooling
systems. Do not leave persons with limited mobility,
children, or pets unattended in extremely hot spaces
with only the evaporative cooler as a cooling source.
Exposure to extremely high temperatures can result in
death or serious personal injury.
The unit works by pumping water from the water container
and distributing it across the filter media. The fan pulls warm
air from the rear of the unit and through the filter media. As
the air goes through the filter media, its warmth is absorbed
into the water. The fan then propels the cool and humidified
air through the front of unit and into the desired area.
FILLING THE WATER CONTAINER
See Figures 6 - 7.
 Disconnect the evaporative cooler from the power supply.
 Using the handle, carefully pull the water container away
from the unit. Water can be added with the container
partially or completely removed.
NOTE: Clean the water container with soap and water
before first use.
 Add water until the fluid level rises to the max fill line in
the tank.
NOTE: Although tap water can be used, we recommend
using distilled or filtered water to reduce mineral deposits
which can clog the filter media.
 Replace the water container.
NOTE: Always empty the water container when the evapora-
tive cooler is not in use.

OPERATION

WARNING:
When removing, filling, or transporting water container, be
careful not to spill water. Do not overfill container. Spilled
water can result in a slippery surface, create a slip and
fall hazard, and cause property damage.
OPERATING THE EVAPORATIVE COOLER
See Figures 8 - 14.
WARNING:
Only move appliance in the complete upright position on
all four casters. Do not tilt or tip over appliance; tilting or
tipping unit can cause water to spill, resulting in possible
electric shock, slip and fall hazard, or property damage.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Do not use the evaporative cooler to disperse liquid
medicines, chemicals, or any liquids other than clean
water. These substances could result in serious injury or
illness to the operator or bystanders.
 Connect the evaporative cooler to the power supply.
 Position the unit and press down on the wheel lock to
secure the casters in place and prevent the unit from
moving during use.
To turn the evaporative cooler on/off:
 Press the POWER button on the control panel or remote
control. When the unit is on, the digital display will be
illuminated.
 To turn the unit off, press the POWER button again.
NOTE: It is normal for odor to be emitted from the filter
media during first use. The smell will dissipate after a few
hours of operation.
To adjust the fan speed:
 Press the FAN button on the control panel or remote
control. Each time the FAN button is pressed, bars will
appear above the fan icon (
indicating Speed 4 (
Speed 1 ( ).
To turn the pump on and off:
 Press the COOL/HUMIDIFY button on the control panel
or remote control. The cool icon ( ) or humidify icon ( )
will appear in the digital display.
8 — English
) in the digital display
), Speed 3 ( ), Speed 2 ( ), and