Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. ALWAYS point s pray g uninasafe direction and squeeze
spray g un trigger to release retained high water pressure.
iMPORTANT:
Spray g un traps high water p ressure, even
when engine i sstopped and water i s disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
_
nderlying tissues, ieading to serious injury and
_ossibteamputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
o Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYS pointspraygun in safedirectionand squeeze spray
gun trigger,to release high pressure everytime you stop
engine.Engage trigger lockwhennot in use.
4.
Engagetrigger lock on spray gun when not in use.
How te Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and PrecisionSpray
TM
Sebctor. There is
also a hook at the front of the accessory tray to hoid your
high pressure hose. identify alI accessories with the
iflustration on page 6.
NOTE:The extra hob in the tray is for storing a utiiity brush.
The extra ciip in the tray is for storing a turbo nozzle.The
brush and turbo nozzie are NOT included with your pressure
washer. You can buy these items as optional accessories.
1.
Mace PrecisionSpray
TM
Selector througll hole on
accessory tray, as shown.
f
2.
Mace spray gun through hole on accessory tray on rigllt
side of unit.
NOTE:You may also usethe hooks attached to the base and
handle to store your gun and PrecisionSpray
TM
Selector.
3.
Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
How te Use PrecisionSpray
TM
Selector
Refer to the PrecisionSpray
TM
Selector instruction sheet for
proper use.
NOTICE
Product damagewiii occur if the gun trigger is squeezed
while the Seiector is in-behveen nozzle settings.
NEVER turnthe Selector whilespraying.
Cteaning and Applying Detergent
NEVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
rnanufacturers i nstructions.
Te apply detergent feibw these steps:
1.
Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
iMPORTANT:Be sure engine is off and allowed to cool before
switching detergent siphoning hoses.
WARNING
Contact with muffler area can result in serious
burns.
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DONOT touch hot partsand AVOID hot exhaustgases.
o Allowequipment t o cool beforetouching.
2.
Prepare detergent soiution as required by job.
3.
Make sure detergent shut=off valve on cleaning tank is in
"Off" position.
4.
If using cleaning tank, pour detergent into cleaning tank.
NOTE:The cleaning tank holds one gaiion.
5.
Rotate PrecisionSpray
TM
Selector to a iow pressure
position, as described in the PrecisionSpray
TM
Selector
instuction sheet.
NOTE:Detergentcannot be appiied with the PrecisionSpray
TM
Selector in a higil pressure position.
6.
Make sure garden hose is connected to water inieL
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
You must attach alI hoses before you sta_
Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
Damageto equipment resulting from failure to follow this
instruction will void warranty.
12
Publicidad
Tabla de contenido
