Fuses; Cutting Height Pedal; Fuel Shut Off Valve; Tracking - Jonsered Z61XFR Manual Del Operador

CONTROLS

Fuses

Fuses are located on the left hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling.

Cutting Height Pedal

The deck cutting height is set by pressing the foot
pedal forward, lifting the deck. To lower the deck,
apply pressure to the top side of the foot pedal.
Let it to pivot while the lift arm rotates to the rear
of the unit. To stop at the desired cutting position,
rotate the foot pedal down into the notch in the
height plate. The cutting height range is from
1-1/2" to 4-1/2" in 1/4" increments. Heights are
measured from the ground up to the blade tip.
WARNING! Do not make adjustments
unless the engine is stopped and the park
brake is activated.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.

Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of
the seat. The valve is off when the handle tab is
turned perpendicular to the fuel line.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the
tracking bolts. The bolts act as limiting devices
for the motion control levers when in the full-
forward position.
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
3. Back the bolts out until flush with nut.
4. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on
the right hand side until the unit noticeably
starts drifting right.
5. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight.
15