Adjusting The Mower Deck; Cleaning - Jonsered Z42F Manual Del Operador

MAINTENANCE

Adjusting the Mower Deck

Leveling deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to
the correct pressure. See Technical Data /
Transmission. If tires are under or over inflated,
the deck cannot be correctly adjusted. Raise the
deck to the highest (transport) position.
The deck must be adjusted slightly higher in the
rear.
NOTE: To insure the precision of the leveling
procedure, the mower deck drive belt must be
installed before leveling the deck.
1. Wear heavy gloves. Turn each outer blade tip
to align front to rear with the deck side-to-side.
2. Measure from the floor surface up to the
bottom of the blade tip on the discharge side
of the mower deck. Record the measurement.
3. Move to the opposite side, check that
measurement is the same. If adjustment is
required—with a 3/4" or adjustable wrench,
turn the lift link adjustment nuts on either
side counter clockwise to lower or clockwise
to raise. Adjust until both measurements are
equal.
4. Turn either blade to align with the deck front-
to-rear. If the front blade tip does not measure
1/4" to 3/8" lower than the rear, remove the
foot plate access the front deck adjustment.
With an adjustable wrench, loosen the rear
jam nut on the front suspension linkage.
26
Make adjustment to level with the front lift link
nut. Clockwise raises the front of the mower,
counter clockwise will lower the front. Adjust
the nut until rear blade tip is 1/4" to 3/8"
higher than the front blade tip.
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, additional adjustments may be
required to get the desired cut.

Cleaning

Regular cleaning, especially under the mower
deck, will increase the machine's life-span. Make
it a habit to clean the machine directly after use
(after it is cooled), before the debris sticks.
Do not spray water on the top of the mower
deck. Use compressed air to clean the top side
of mower deck. Regularly clean the underside of
the deck with normal water pressure. Do not use
a high pressure washer or steam cleaner. Avoid
spraying engine and electrical components with
water.
For models fitted with a cleanout port, attach the
quick connect (from the accessory packet) to any
garden hose. After mowing, snap the hose to the
cleanout port and turn on water supply.
Restart the mower and engage the blades to use
the spinning action to wash away debris. Make
sure the hose is away from the mower blades.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.