What If There Are Problems; Technical Data; Disposal; Warranty And Service - Beurer MC3000 Instrucciones De Uso

8.

What if there are problems?

Problem
Massage heads are
moving slowly.
Massage heads are
moving in the upper or
lower area only.
Grinding noises during
operation.
The massage cannot be
started.
The massage function
stops when the chair is in
operation.
9.

Technical Data

Product description
Mains voltage/frequency
Energy consumption
Dimensions (in flat position)
Weight
Maximum load capacity
10.

Disposal

Observe the local regulations for material disposal.
Dispose of the unit in accordance with EC Directive
2002/96/EC – WEEE (Waste Electrical and Electronic
Equipment).
11.

Warranty and service

In the event of a warranty claim or service case,
please contact Customer Services in your respective
country.
You can find the address in the enclosed address list.
Cause
The load on the massage heads is too
great.
The massage was only activated for the
limited area in question.
These sounds are normal and are caused
by the operation of the motor or from the
massage heads that are rubbing against
the cushion.
The mains plug is not connected to the
socket.
The 3D Shiatsu massage was not switched
on at the control element.
The maximum operation period was
reached.
Massage chair MC3000
100-240 V ~ 50-60 Hz
42 W
Length 140.5 cm, width 76.0 cm, height 99.0 cm
Net: 30 kg, with packaging 36.5 kg
135 kg
Solution
> Reduce the contact pressure from
your body.
Press the FULL BACK, UPPER
>
BACK or LOWER BACK button to
change or extend the area.
No action is necessary.
> Plug the mains plug into the socket.
> Switch on the massage chair using
the on / off button
> Switch off the massage chair and
allow to cool down for 30 minutes
before switching on again.
If you have any questions, please contact
the local authorities responsible for waste
disposal.
21
.