Craftsman 580.753011 Instrucciones De Uso página 16

5. Using a garden hose, remove additional debris by
back flushing water through nozzle extension.
Back flush between 30 to 60 seconds.
6. Reinstall spray tip and in-line filter into nozzle
extension.
7. Reconnect nozzle extension to spray gun.
8. Reconnect water supply, turn on water, and start
engine.
9. Test pressure washer by operating with each
quick connect spray tips.
O-Ring Maintenance
Purchase an O-Ring Repair Kit at your local Sears or by
calling 1-800-366-PART or online at ,,_,_/w.sears.com. it
is not included with the pressure washer. This kit
includes replacement o-rings, rubber washer and water
inlet filter. Refer to the instruction sheet provided in the
kit to service your unit's o-rings.
l 1
• NEVER repair leaking connections with sealant of any
kind, Replace o-ring or seal.
Pump Maintenance
This model does not require any pump maintenance.
The pump is prequbricated and sealed, requiring no
additional lubrication for the life of the pump.
ENGINE MAINTENANCE
VVARNING
WHEN ADJUSTmNG OR MAKING REPAIRS TO YOUR
PRESSURE WASHER
* Disconnect the spark plug wire from the spark plug and
place the wire where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester,
DO NOT check for spark with spark plug removed.
Checking Oil Leve_
Oil level should be checked prior to each use or at
least every 5 hours of operation. Keep oil level
maintained.
Changing
Oi_
Change engine oil after the first 5 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
CAUTION
Used motor oil has been shown to cause skin cancer in
certain laboratory animals,
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO
COLLECTION CENTERS.
Change oil while engine is still warm from running, as
follows:
1. Disconnect spark plug wire and keep it away from
spark plug.
2. Place a suitable container below engine to catch
used oil. Remove dipstick, drain plug and washer.
3. Allow oil to drain completely. Reinstall drain plug
and washer. Tighten drain plug securely.
4. Place pressure washer on a level surface.
5. Fill engine to the outer edge of the oil filler hole
with recommended oil (see page 7).
6. Screw in the dipstick and tighten securely.
7. Wipe up any remaining oil.
8. Reconnect spark plug wire to spark plug.
16