Service Spark Plug; Carburetor - Craftsman 580.752810 Instrucciones De Uso

To service the air cleaner, follow these steps:
1. Loosen two screws and lift off cover.
Two Screws
Base
2. Carefully remove air cleaner from base.
3. Install clean (or new) air cleaner in base. Air
cleaner must fit securely in base.
4. Place cover over air cleaner and tighten screws.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.

Service Spark Plug

Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1. Clean area around spark plug.
2. Remove and inspect spark plug.
3. Replace spark plug if electrodes are worn, or if
insulator is cracked or chipped.
4. For replacement use either the standard resistor
spark plug, Champion RC12YC or the long life
platinum spark plug, Champion RC12PYP.
5. Check electrode gap with wire feeler gauge and
set gap at 0.020 inches (0.50mm), if necessary.
6. Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.

Carburetor

If you think your carburetor needs adjusting, see your
nearest Sears service center. Engine performance
may be affected at altitudes above 3000 feet. For
operation at higher elevations, contact your nearest
Sears service center.
Spark Arrester Service
Your engine is not factory-equipped with a spark
arrester. In some areas, it is illegal to operate an
engine without a spark arrester. Check local laws and
regulations. A spark arrester is available from your
Cover
nearest Sears service center. If you need to order a
spark arrester, please call 1-800-366-PART.
The spark arrester must be serviced every 50 hours to
keep it functioning as designed.
Cartridge
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing the
spark arrester.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
• The pressure washer must be at least 5 feet from
structures having combustible walls and/or other
combustible materials.
• Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
• In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code).
Other states may have similar laws. Federal laws apply on
federal lands. If you equip the muffler with a spark arrester,
it must be maintained in effective working order.
• Remove spark arrester screen for cleaning and
inspection.
• Replace if screen is damaged.
Air Cooling System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly. For this reason, we recommend you
have an authorized Sears service dealer clean the
cooling system per recommended intervals (see
"Maintenance Schedule" on page 15). Equally
important is to keep top of engine free from debris.
See "Clean Debris".
18
WARNING
Running engines produce heat.
Temperature of muffler and nearby areas
can reach or exceed 150°F (65°C).
Severe burns can occur on contact.
Combustible debris, such as leaves, grass,
brush, etc. can catch fire.