Simpson PS60843 Manual De Instrucciones página 9

4400 psi 4.0 gpm
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect Spray
4
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
Release Air
7
from System
Release all
air from pump and
high pressure hose
by depressing trigger
until a steady stream
of water is present.
Approximately
30 seconds.
30 S
Move the
10
Choke to the
CLOSED
Position
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using this product.
Connect QC
5
Nozzles to
Spray Wand
Pull quick connect
coupler back and
insert nozzle. Release
quick connect coupler
and twist nozzle
to make sure it is
secure in coupler.
Verify the Fuel
8
Switch is
turned to the
ON Position
Pull the Recoil
11
Starter Grip
Pull the
recoil starter grip to
start the engine.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the
unit without water
supply connected
and turned on. Use
Cold Water Only.
Verify the
9
Engine Switch
is turned to the
ON Position
Move the
12
Choke to the
OPEN Position
Gradually move
the Choke to the
OPEN Position after
engine starts.

Publicidad

Tabla de contenido
loading

Tabla de contenido