Controls - Haier HI50IB Instrucciones De Instalación Y Manual Del Usuario

ICE MACHINE USE

CONTROLS

ICE HARVEST BIN FULL
ON/OFF CLEAN ADJUST MODE
Bin Full (Red) LED indicator light
When Bin Full is lit, the ice storage bin is full of ice or something is blocking
the bin-full probe. The ice machine will stop working. When ice cubes are
removed from the ice storage bin, freeing the bin-full probe, the red LED will
flash for 3 minutes, and then the ice machine will restart and return to the
ice making mode.
Ice Making (Green) LED indicator light
When Ice Making is lit, the unit is working in the ice making mode controlled
by a temperature probe on the evaporator. When the green LED flashes, the
unit is working in the ice making mode controlled by a fixed timer.
Ice Harvest (Yellow) LED indicator light
When this is lit, the unit is working in the ice harvest mode controlled by the
ice-full probe.
Mode button: Mainly for Service
The MODE button is used to change between the Ice Making Mode and Ice
Harvest Mode. The operating mode can be determined from the status of
the green (Ice Making), and yellow (Ice Harvest) LEDs.
Press and release the MODE button to force the ice machine to switch from
the current state.
Adjust button
When this is pressed and held for longer than 3 seconds, the unit will enter
the Ice Size Adjustment mode. The mode can be judged from the status of
the yellow LEDs.
To adjust the ice size:
The ADJUST button is used to enter the Ice Size Adjustment mode. The
HARVEST LED must be lit solid before attempting to adjust ice size. Press
and hold the ADJUST button until the yellow HARVEST LED begins blinking.
This usually occurs after 3 seconds. Once the yellow LED starts to blink,
release the button. The yellow LED blinks continuously while in the Ice Size
Adjustment mode.
18
49-60811