Water Distribution Tube Cleaning - Haier HI50IB Instrucciones De Instalación Y Manual Del Usuario

Máquina de hielo automatic para debajo de la encimera
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ICE MACHINE CARE
CLEANING (Cont.)
CONDENSER CLEANING (Cont.)
1. Unplug the ice machine or disconnect
power.
2. Use a Phillips screwdriver to remove the
lower front louver.
3. Remove dirt and lint from the condenser
and the unit compartment with the brush
attachment of a vacuum cleaner.
4. Reassemble the lower front louver.
5. Plug in the ice machine or reconnect
power.

WATER DISTRIBUTION TUBE CLEANING

When you find the ice cubes are incompletely formed or the output is low,
the water distribution tube may be blocked. Turn off the power button,
use a Phillips screwdriver to remove the two screws from the cover of the
distribution tube located at the top of the evaporator, gently take out the
water distribution tube, locate the holes in the distribution tube and use a
pointed object such as a toothpick to dredge the holes. Then put the water
distribution tube and cover back to its original position. If the tube is badly
blocked, clean it as follows:
1. Shut off the water supply.
2. Disconnect the water hose from the distribution tube.
3. Use a Phillips screwdriver to remove the two distribution tube cover
screws at the top of the evaporator, and gently remove the distribution
tube.
4. With a brush, clean the tube with a diluted solution of warm water and a
mild detergent such as dishwashing liquid. After removing the dirt and lint
from the surface, rinse the tube with clean water.
5. Replace the distribution tube and cover.
6. Reconnect the water supply.
22
49-60811

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido