Installing Remote Control Batteries - OK. ODL 40450-B Manual De Instrucciones

INSTALL OF STAND
1 Attach the bottom plate and fix with the screws. Fix the stand adaptor with the screws on the TV
backside.
Connect the aerial plug with the 75 Ω socket of the TV. Insert the mains plug into a wall socket and
2
the power indicator turns red remains the TV in standby mode.
SWITCH ON THE TV
Switch on the TV and the power indicator turns on green.
3

INSTALLING REMOTE CONTROL BATTERIES

Open the battery compartment cover. Insert 2 batteries (AAA, 1.5V). Ensure the + and − polarities of
the batteries line up with the markings inside the case. Close the cover.
BASIC OPERATION OF CONTROL KEYS
4 • To switch on the TV, press the power key
• To switch channels: Press CH+/– on the TV or press CH+/– or enter number on the remote control.
• To adjust volume press VOL +/– on the TV unit or remote control.
• To watch from a connected device, press INPUT on the remote control or TV and select the
desire device.
• Press MENU to enter the menu.
SELECTING CONNECTED DEVICES
In INPUT you can select all connected devices with the television.
5
Press INPUT on TV and select the desired device.
CONNECTIONS
ANT/RF
HDMI 1/2/3
SCART
YPbPr
AV
DTV
ATV
PC
Media
IM_ODL40450_A141030_V03_HR.indb 37
37
on the main unit or remote control.
Analogue television reception
An HDMI connection guarantees the best image and sound quality. Video
and audio signals are combined in an HDMI cable. Use HDMI connections
for TV signals in high-definition (HD) quality.
Audio and video signals can be transferred by means of a SCART cable.
SCART connections can transfer RGB video signals but cannot transfer
television signals in HD (high-definition) format.
With component video (Y Pb Pr) only video signals can be transferred.
If you would also like to receive sound signals, you must connect an L/R
audio cable.
Plug the antenna connector into the 75 Ω socket of the set-top box.
Connect the television set to the set-top box by means of an A/V cable.
Select digital signal TV input.
Select analog signal TV input.
Select video signal input from PC.
Select input from USB interface.
EN
30/10/14 6:02 PM