Commissioning - Schneider Airsystems SBS Set Standard Manual De Instrucciones Original

GB
SLM
WARNING
Rotating parts!
Wear a hairnet!
Avoid tangling of hair or clothing!
Wear only protective clothing or securely
fastened clothing that fits snugly.
WARNING
Abrasives and tools may be ejected!
Make sure the tool is seated securely!
No-load operation prohibited!
Observe the maximum speed and circum-
ferential speed of the tools used!
Never use wire brushes!
- Collet chuck support:
Insert the abrasive / tool at least 15 mm.
- Belt grinder:
Always release the grinding arm before
starting work.
- Angle grinder:
Do not operate without a protective hood.
CAUTION
Vibrations transmitted from device to
operator during load operation.
Beware
Wear safety gloves
CAUTION
Workpiece or metal shavings may be
very hot!
Wear safety gloves!
CAUTION
Dangerous obstacle!
Air hoses laid on the ground.
Avoid or pay close attention.
II/ 8
NOTICE
Sparks can cause fires.
Some material machining methods gen-
erate sparks that can cause fires or
smouldering!
Avoid spark formation!
Make sure the unit is used for the
intended purpose!
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage, financial
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Prohibited: manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
• Prohibited: Use of tools or abrasives oth-
er than those specified, touching rotating
parts.
2.4

Commissioning

Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
loss, environmental