Powering On/Off - Ega Master 79789 Manual De Instrucciones

2.2 Powering on/Off
Information
The diagrams above show how to power on the camera MasterEx intrinsically safe. The same
procedure is required to turn the camera MasterEx intrinsically safe off. Once it is turned off no LEDs
should be lit.
2.3 Installing the camera MasterEx intrinsically safe With an Operating System
This section will provide details on how to install the camera MasterEx intrinsically safe to be used
with a supported host operating system. Although the camera MasterEx intrinsically safe supports
various Linux versions with the PTP library installed this manual only focuses on Windows operating
systems. The camera MasterEx intrinsically safe is PTP compliant so should work in the same way as
many other digital cameras do with various operating systems
The camera MasterEx intrinsically safe must be powered on and the green status LED must be
solid before connecting to a host operating system, otherwise the operating system will not establish
communication with the camera. Once the green LED has become solid connect the Camera MasterEx
intrinsically safe via a USB cable to the host computer.
34
The camera MasterEx intrinsically safe must be fully powered on before plugging
a USB cable into the camera or to take a picture. This will be indicated when the
Press and hold the
"FLASH" and "RECORD"
buttons simultaneously
until the "ON" LED starts
to flash green.
green LED has stopped flashing.
Green LED will flash for ~10 seconds
while the camera boots. The Blue and
Red LED will flash briefly during boot up.
The Green LED then goes solid when
ready for operation.