Ega Master 79789 Manual De Instrucciones página 60

Once installation is complete, go to Start -> Programs -> The manufacturer -> camera MasterEx
intrinsically safe and run the desired installation configuration.
The following window should be displayed:
To put the camera MasterEx intrinsically safe into upgrade mode, power the camera down and then
press and hold the 'trigger' and 'flash enable' buttons until the blue LED begins flashing (this should be
the only LED lit).
Next, plug a USB cable into the camera MasterEx intrinsically safe, and into the PC. The upgrade
application should then prompt you to press the start button once it has recognised the camera MasterEx
intrinsically safe is connected and in the correct mode. Follow the on-screen instructions.
60