Technical Specifications - Velleman PMLCDL Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
W
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken
to a specialized company for recycling. This device should be returned to your distributor or to a local
recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Applications
Voltmeter, thermometer, PH meter, dB meter, Watt meter, current meter, capacitance meter, Lux meter, LCR
meter, other industrial & domestic uses
3. Operation
If needed, add proper voltage dividers (not included) and decimal point wire jumper:
(RA and RB are 1/2 W 0.5% metal film resistors)
Max. voltage to be measured
200 mV
20 V
200 V
500 V
Connect an appropriate power supply to the panel meter (depending on the model, see Technical
•
Specifications).
For ranges other than 200mV, generate an input voltage of exactly half the measuring range (e.g. 100V for
•
200V range) and carefully adjust the semi-fixed resistor R2 until you obtain the same reading on the
display.
Connect the input voltage to be measured to +Vin and -Vin. The input voltage should be DC only.
•
4.

Technical Specifications

display
input sensitivity
power supply
decimal point selection
automatic polarity indication
figure height
sampling rate
guaranteed zero reading for 0V input
high input impedance
accuracy
power consumption
dimensions
dissipation
power requirement
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage
or injury resulting from (incorrect) use of this device.
V. 02 – 08/07/2015
PMLCDL
USER MANUAL
Proper Voltage Divider
-
Disconnect wire jumper in RB.
RB = 9.9MΩ ; RA = 100kΩ
Disconnect wire jumper in RB.
RB = 9.99MΩ ; RA = 10kΩ
Disconnect wire jumper in RB.
RB = 9.999MΩ ; RA = 1kΩ
3 1/2-digit LCD
200 mV FS
9 VDC (7 - 12 VDC)
with wire jumper
13 mm (0.52")
2 - 3 readings / sec.
> 100 MOhm
± 0.5%
1 mA DC
68 x 44 mm
1 - 2 mA
10 - 20 mW
2
Decimal Point
Short-circuit P3 - P0
Short-circuit P2 - P0
Short-circuit P3 - P0
-
©Velleman nv