Parent Unit - Philips SKM7487NC/84 Instrucciones De Manejo

Getting your baby monitor ready for use
Battery operated use
1 Open the battery compartment by turning the cover (A-9) to
the left (1 OPEN), using the palm of your hand.
Take off the cover.
2 Insert four 1.5V, AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied; we recommend Philips Alkaline batteries).
3 Put the battery compartment cover (A-9) back in place.
Close the compartment by turning the cover (A-9) to the
right (CLOSE 2), using the palm of your hand.
The baby unit is now ready for battery operated use!

Parent unit

The parent unit can be mains or battery operated.When
batteries are inserted, you will have an automatic back-up in
case of mains failure and you can carry the unit in and around
the house.
Mains operated use
1 Connect the the power adapter cord (B-14) to the power
supply jack (DC 3.6V / 200mA - B-3) of the parent unit.
2 Connect the AC power adapter (B-14) to a wall outlet.
The parent unit is now ready for mains operated use!
Battery operated use
1 Open the battery compartment by sliding the cover (B-12)
downwards.
EN
7