Deactivating Security Code; Touch Sensor Tone - Kenwood KDC-MP2035 Manual De Instrucciones

⁄
• You can set the Security Code with a 4 digit number of your
choice.
• The Security Code cannot be displayed or referenced. Make
a note of the Security Code and treasure it up.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
When "MENU" is displayed, "CODE SET" is also
displayed.
3
Enter Security Code mode
Press the Control knob for at least 1 second.
When "ENTER" is displayed, "CODE" is also
displayed.
4
Select the digits to enter
Push the Control knob towards [4] or [¢].
5
Select the Security Code numbers
Push the Control knob towards [FM] or [AM].
6
Repeat steps 4 and 5, and complete the
Security Code.
7
Confirm the Security Code
Press the Control knob for at least 3 seconds.
When "RE-ENTER" is displayed, "CODE" is also
displayed.
8
Do the step 4 through 7 operation, and reenter
the Security Code.
"APPROVED" is displayed.
The Security Code function activates.
⁄
• If you enter the wrong Code in steps 4 through 6, repeat
from step 4.
Resetting the Security Code function when the
audio unit is first used after removed from the
battery power source or the Reset button is
pressed
1
Turn the power ON.
2
Do the step 4 through 7 step operation, and
reenter the Security Code.
"APPROVED" is displayed.
Now, you can use the unit.
⁄
• When the Security Code function is activated, "CODE
SET" changes to "CODE CLR".
• To deactivate the Security Code function, see the next
section <Deactivating Security Code>.
Function of KDC-MP2035/KDC-MP235
In Standby mode

Deactivating Security Code

To deactivate the Security Code function.
1
Select Security Code mode
Push the Control knob towards [FM] or [AM].
Select the "CODE CLR" display.
2
Enter Security Code mode
Press the Control knob for at least 1 second.
When "ENTER" is displayed, "CODE" is also
displayed.
3
Select the digits to enter
Push the Control knob towards [4] or [¢].
4
Select the Security Code numbers
Push the Control knob towards [FM] or [AM].
5
Repeat steps 3 and 4, and complete the
Security Code.
6
Press the Control knob for at least 3 seconds.
"CLEAR" is displayed.
The Security Code function deactivates.
⁄
• If a wrong security code is entered, "ERROR" is displayed.
Enter a correct security code.
In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound)
ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
"BEEP OFF" Beep canceled.
19
|
English