If It Doesn't Work As Expected, P - SoundRacer SR0101V8AA Manual De Instrucciones

4
when the engine is slowing down. The beep
indicates that SoundRacer has found the
alternator signal. After about 3-5 seconds,
when the engine is down to the idling rpm,
you should hear two beeps indicating that
SoundRacer has detected the idling rpm.
That's it! Now you can press down on the
5.
throttle and hear a Super Sports Car engine
rev up.
Drive off and enjoy, but always drive safely!
2. If it does not works as expected
SoundRacer cannot detect the engine rpm?
If there is no first beep or second beeps or the sound
does not follow the engine rpm, then SoundRacer has
a problem detecting the alternator signal and rpm. This
can happen if the alternator signal is too weak. In that
case it can help to increase the electrical load on the
alternator by turning on the headlights, seat heating,
rear window heating or other electrical equipment.
If the engine sound repeatedly changes to higher rpm
when the engine is idling then try to lock the idling to a
higher rpm, see 3. Tips & Tricks. This makes the rpm
detection avoid the higher noise levels that some cars