Publicidad
Idiomas disponibles
Idiomas disponibles
How To Control The Unit
Three ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
A. Master/Slave operation
The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great built-in
pre-programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: when working at Auto-run or Sound Control mode operation
Slave units: DMX start address MUST be set to 001. (First DIP switch = ON, all other
are OFF)
B. Easy sound active and Auto mode
Set sound active mode: Tenth DIP switch = ON , first to sixth DIP switch ON is mode of adjustable speed ,all other are
OFF
Set Auto mode: Ninth and Tenth DIP switch = ON ,first to sixth DIP switch on is speed mode ,all other are OFF, first to
sixth DIP switch ON is mode of adjustable speed ,all other are OFF
C. Universal DMX controller
When using a universal DMX controller to control the chain of units, you have to set DMX address by Dip switches from 1
to 9 to make sure all the units will receive its DMX signal.
Please refer to the following diagram to know how to address your DMX 512 system in the binary code.
DMX 512 Address Chart:
Dip-switches
# 1
Value
1
5. DMX 512 Configuration
0: OFF 1: ON -: OFF or ON
Function
1
Sound
Auto
DMX512
11～200
Channel 1
201～255
Channel 2
0～255
Channel 3
0～255
Channel 4
0～255
Channel 5
0～255
Channel 6
0～255
Channel 7
0～255
Auto-run, Sound Control
Master
Slave
1
# 2
# 3
# 4
# 5
2
4
8
16
DIPSWITCH CHART
2
3
4
5
Speed selection
(Slow→Fast)
SET DMX ADDRESS FOR DMX MODE
DMX Auto
DMX Sound
No.1 LED Gobo
No.2 LED Gobo
No.3 LED Gobo
No.1 Motor Scanning
No.2 Motor Scanning
No.3 Motor Scanning
0
0
0
0
# 6
# 7
# 8
# 9
32
64
128
256
6
7
8
-
-
-
-
0
0
0
#10
2-light show
9
10
0
1
1
1
0
0
0
Publicidad
