Hkoenig BOE54 Manual De Instrucciones página 9

the actual water temperature is up to the set temperature, the heating tube will not work, and
electronic board start the time, about 4 hour later, LCD no display, which means the kettle back
to standby. When, after LCD no display, the kettle back to standby mode.
When the boiling water temperature is up to the set temperature, then heat pipes stop working,
and the kettle began to heat preservation.
When the water temperature lower than the set temperature, heat pipes began to heat and up to
setting temperature, and LCD and the
water temperature is equal to or higher than the set temperature, the heat pipe does not work, in
the insulation state, LCD and the
In the process of heat preservation, if press
water.
When entered into the state of thermal insulation, electronic board start time, about 4 hour later,
the LCD no display, then the kettle back to standby Within an hour, press 'I/O', LCD no display,
the kettle back to standby.
HOW TO CLEAN KETTLE
1. Please unplug the power plug and let the pot become
cool before cleaning.
2. Please do not immerse the kettle, power cord, power
plug and power socket into water.
3. Please ensure the electronic line circuit dry.
4. Please wipe the kettle body with a damp cloth. Please
do not use scouring powder, cleaning ointment product,
they will damage the surface characteristics of kettle.
5. Cleaning and maintenance should not be carried out by
children unless they are at least 8 years of age and are
supervised by an adult.
sign under the LCD on right keep flashing. When the
sign under the LCD on right will not flash, and repeat.
key to exit heat preservation function, return to boil