Auto Preset Ch - Sylvania 6427GFG A Manual Del Usuario

AUTO PRESET CH

If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform AUTO
PRESET CH again. This function lets you easily
select the receivable channels with [CH K / L ] and
the TV memorizes them even if you switch wires.
1
4
7
– /ENT
CH K / L
MENU
MENU
NOTE:
• Make sure if the TV is connected to antenna or cable.
When aerial antenna is connected, select "AUTO PRESET
CH (TV)" or "(TV/DTV)" at step 3. When connected to
CATV, select "AUTO PRESET CH (CATV)".
TV
When scanning TV or CATV only
1
Select analog mode by pressing [DTV/TV].
2
Display the MENU screen.
• Press [MENU] on the remote control.
The following MENU screen is displayed.
PICTURE
CHANNEL SET
[ENG]/ESP/FRA
V-CHIP SET UP
CAPTION [OFF]
3
Select "CHANNEL SET".
• Using [CH K / L ] on the remote control, select
"CHANNEL SET".
PICTURE
CHANNEL SET
[ENG]/ESP/FRA
V-CHIP SET UP
CAPTION [OFF]
• Press [VOL X ] on the remote control.
28
EN
2 3
5 6
8 9
CHANNEL
RETURN
0 + 100
CH
VOL X
VOL VOL
CH
INPUT
MUTE
SLEEP
SELECT
4
*Only for TV channels
• Using [CH K / L ] on the remote control, select
"AUTO PRESET CH(TV)".
ADD/DELETE
AUTO PRESET CH(TV)
AUTO PRESET CH(CATV)
AUTO PRESET CH(DTV/TV)
• Press [VOL X ] on the remote control.
Scanning and memorizing the channels auto-
matically starts.
AUTO PRESET CH(TV)
• When the scanning and memorizing are com-
pleted, the memorized smallest channel in the
analog broadcasting will be displayed.
4
*Only for CATV channels
• Using [CH K / L ] on the remote control, select
"AUTO PRESET CH(CATV)".
ADD/DELETE
AUTO PRESET CH(TV)
AUTO PRESET CH(CATV)
AUTO PRESET CH(DTV/TV)
• Press [VOL X ] on the remote control.
Scanning and memorizing the channels auto-
matically starts.
AUTO PRESET CH(CATV)
• When the scanning and memorizing are com-
pleted, the memorized smallest channel in the
CATV will be displayed.